|
- Extruded homogeneous vinyl
- Use as either worksurface or floor mat
- Smooth surface on one side is easy to clean and maintain
- Non-glare finish on one side makes small parts easy to identify
- Reversible vinyl saves money, extends mat life
- Easy to cut - configure to fit your requirements
- Economy choice meeting ANSI/ESD S20.20 minimum recommended requirements
- RTT: <10E9 ohms per ESD S4.1
- RTG: <10E9 ohms per ESD S4.1
- Thickness: 0.100" (2.5mm)
- Item 13160 Common Point Ground Cord and Item 12000 Universal Snap Kit are included with Mat Kits
- Note: Since it does not have a conductive layer, Statfree B™ is not suitable for use with continuous monitors
- Lead-free RoHS compliant
- Made in America
"The most important functional consideration for worksurfaces is the RTG resistance from the top of the surface to the groundable point." ANSI/ESD S20.20 Table 1 recommends a requirement of less than 1 X 10^9 ohms. "If Charged Device Model damage is a concern then setting a lower resistance limit should be considered. Typically, 1 x1 0^6 ohms." "Durability factors that should be considered are hardness, abrasion resistance, tear resistance, etc. Worksurfaces may require special heat resistant materials. Light reflection may be an important ergonomic consideration." (Ref: TR 20.20 section 5.3.1).
|
|