• Analogue Compliance Verification Surface Resistance
Checker
Used for determining if a surface is dissipative, conductive
or insulative
• Automatic Test Range Voltage Selection Compliance
Verification required by EN 61340-5-1
Starts tests at 10 volts and automatically switches to 100
volts if the measurement is over 10E5 ohms • Portable Operation with 9 Volt Battery
No charging or sourcing of special batteries needed • LED Illuminates When Battery Power is Low
Prevents operator from making bad measurements • Test Kit Includes Set of 2.27 kilograms Electrodes and
Leads
Use with the meter to measure resistance point-to-point
(Rp-p) and resistance to ground (Rg) • NIST Calibrated with Certificate
Calibrated with accepted procedures and standards
traceable to the National Institute of Standards Technology • Made in America
